Products protected by the

following U.S. Patents:

DES - 376,280

DES - 342,843

DES - 477,935

DES - 324,140

The assembly process is very simple and should only take a few minutes to set up. We suggest that you save the original cartons for future transportation. It will further protect your stands and save you valuable time and energy looking for cartons that more than likely will not fit.

With the descriptive instructions on this page you can learn to assemble your ShowModel Regi-Stand quickly and easily. Any questions or comments will gladly be accepted by giving us a call. We look forward to doing more business in the future.

NOTE: Base assembly is identical to Professional Regi-Stand base assembly.

ShowModel Regi-Stand Assembly
1.  Insert yellow rod tip in yellow T-Nut installed permanently in the base. Hand tighten with Wing Nut installed on the yellow rod tip.  Click to enlarge image for greater detail.
2.  Top Shown ready for installation of white Billboard Guide pipes. Pens have been factory installed.  Click to enlarge image for greater detail.
3.  Completed ShowModel table top with guide pipes, and Billboard being installed. Note the eye bolt protruding through the top, ready for your padlock, to protect your valuable leads.  Click to enlarge image for greater detail.